Printing on curved surfaces
Although there are many methods for printing curve surfaces, but in practical applications, simple surface printing and printing of living parts are often difficult, which are eliminated due to limitation of the conditions, thereby facilitating economic recovery opportunities. Lose hands How can this problem be solved? During the recent years, after the actual application, using a printing method on curved surfaces, a large number of processed materials such as latex barrels, buckets, round tables, balls, cups, bowls, plates and other products Printed. Not only can this be used for printing on car symbols, but also for printing on a body of aircraft that are specifically printed. The first good version of the damp-proof drying and then removing, the cutting size and at the curved surfaces at both ends ends with wood or aluminum as a skeleton with a tight bonding tape. It can also be attached directly to the desired surface. This can be made from the version of the required curve surfaces made according to the selection of different materials for the printing of materials. First of all, with the plate and the sheet, the ink needed to write and design, then, one hand is holding a curved surface display from the print area to the surface tight, with a cut on the ink, evenly ink the ink in one Place the side of the blade, then place the blade on the plate to fit a uniform cylinder.
Printing on curved surfaces
Printing on the curved surface
If the printer’s graphics are too large, it places the ink on the design, depending on the situation, but does not take ink out of the underarm. Note that using ink is not very thin, it is also not very moist and not moderate. Printing on small surfaces, printing, solitary operations. The method is to use the rear end of the packaging tape that is attached to the desired position on the curved surface, and then on the other side to press the side of the bed, you can continue printing because the release requires so much attention. , You should select a good label on the lower bar for a lighter output version. If two practical methods of publishing are correct, using this printing method, with easy operation, the requirements of the flexible substrate can be large and small. This number can be more, less, at a low cost, and with the benefits of energy savings.
